Optional Accessories; Replacement Parts - Shure 588SDX Guia Del Usuario

Impedance
LO Z: Microphone rated impedance is 150 Ω (270 Ω actual) for
connection to microphone inputs rated low impedance
HI Z: Microphone impedance is "High" for connection to high-im-
pedance microphone inputs
Sensitivity (at 1,000 Hz)
Open Circuit Voltage* – 55.5 dBV/Pa – 37.0 dBV/Pa*
*1 Pascal=94 dB SPL
Phasing
Positive pressure on the diaphragm produces positive voltage
on pin 2 relative to pin 3 in both HI Z and LO Z modes
Switch
Built-in ON/OFF switch, lockplate to lock switch ON
Connector
Three-pin professional (male XLR) type
Cartridge Shock Mount
Internal rubber vibration-isolator
Swivel Adapter
Positive action, break-resistant, adjustable through 180° slip-out
removal for handheld use, designed for mounting on stand with
5/8-in.–27 thread
Case
Platinum beige enamel die casting with platinum beige steel
grille
Dimensions
See Figure 3
52 mm
(2.129 in.)
OVERALL DIMENSIONS
Net Weight
315 grams (11.1 oz)
Certification
Conforms to European Union directives, eligible to bear CE
marking; meets European Union EMC Immunity Requirements
(EN 50 082-1, 1992); RF radiated (IEC 801-3); ESD (IEC 801-
2); EFT (IEC 801-4).
IMPEDANCE SELECTION
The microphone is shipped connected for low impedance
operation. To change to high impedance, refer to Figure 4 and
proceed as follows:
1. Remove plug element by turning slotted setscrew in
(counterclockwise). Use long-nose pliers to pull plug element
from case, but be careful not to stretch or break wires.
2. Disconnect 2-terminal impedance selection socket from rear
of plug element by pulling it off pin 3.
3. Reconnect impedance selection socket so that pin 3 of plug
element is now connected to RED (high-impedance) lead.
4. Swivel socket so that it does not extend beyond edge of
connector (see inset in Figure 4).
5. Reinsert plug element into microphone; then tighten setscrew
by turning it clockwise.
LO Z HI Z
(1.7 mV) (14.1 mV)
160 mm
(6.45 in.)
FIGURE 3
CARTRIDGE
FURNISHED ACCESSORY
Break-Resistant Swivel Adapter ............................................ A25D

OPTIONAL ACCESSORIES

Desk Stand ................................................................. S37A, S39A
Shock Stopper™ Isolation Mount.......................................... A55M
Windscreen (7 colors available) ............................. A58WS Series
15 mm
(.868 in.) Cable:
4.6 m (15 ft) or 6.1 m (20 ft) 1-conductor with phone plug
(High Impedance)............................................. C15HZ, C20HZ
7.6 m (25 ft) 2-conductor with 3-pin XLR connectors
(Low Impedance).............................................................. C25J

REPLACEMENT PARTS

Cartridge................................................................................ R180
Screen and Grille Assembly ............................................. RK332G
For additional service or parts information, please contact Shure's
Service department at 1-800-516-2525. Outside the United
States, please contact your authorized Shure Service Center.
2
IMPEDANCE SELECTION
CONNECTOR END OF MICROPHONE
FIGURE 4
SWITCH TRANSFORMER
BLUE
ON
OFF
YELLOW
INTERNAL CONNECTIONS
FIGURE 5
PLUG
ELEMENT
IMPEDANCE
SELECTION SOCKET
TERMINAL HOUSING
BLACK
(COMMON)
3
WHITE – LO Z
2
1
RED – HI Z
MALE PLUG