Chef's Choice 681 Manual De Instrucciones página 5

• Plug base unit into a three way grounded 110-120 volt, AC outlet.
• The Kettle power switch (5) has 2 positions - "ON" (I) and "OFF" (O). Place Kettle on
it's base and push the switch down to the "ON" position. The switch will illuminate to
indicate the power is on.
• The Kettle normally switches off automatically within about 30 seconds after the
boiling point is reached.
• The time required for the Kettle to automatically switch off after the boiling point is
reached will vary depending on the amount of water in the Kettle; it will switch off
faster after boiling if filled to its "maximum" level than if filled to only a minimum level.
• If only warm water is desired, you can interrupt the heating procedure at any time by
simply lifting the kettle off of its power base. The power switch will shut "OFF". In order
to restart the heating, place the kettle on its power base and depress the ON/OFF
switch. The switch will light indicating that the power is on.
• The Kettle can be lifted easily from the base for pouring or serving. The pouring spout
has been specially designed to easily pour even small amounts of water.
• Replace the Kettle on the base unit when finished pouring.
• Whenever the kettle is lifted off its base the power switch must be pushed down to the
"ON" position again if you wish to restart the heating of the water. Always check the
water level before turning the power switch "ON". Make certain there are at least
three cups (0.7 liters) of water in Kettle before turning switch "ON". Avoid boiling the
kettle dry.
7
8
9
4
10
Figure 1.
1
2
6
3
5
1. Lid
2. Lid Release Button
3. Water Level Gauge
4. Base Unit
5. Illuminated Power Switch
Pull up to power "OFF"
Push down to power "ON"
6. Handle
7. Spout
8. Stainless Steel Body
9. 360° Power Connector
10. Filter Screen
English — 5