Meta System DEF-COM 3 Manual Del Usuario página 13

PROTECTION BY THE ALARM SYSTEM
The alarm central unit protects the motorcycle against being started and an alarm cycle will be triggered every time:
- the ignition key is turned ON
- an attempt is made to remove or move any part of the motorcycle which is protected by specific switches (for example if the seat or
the storage compartment is opened ...
- the motorcycle is moved
- the alarm system's supply cables are disconnected or cut or if the motorcycle's battery is disconnected
EN
STOP MODE – LIMITING CURRENT CONSUMPTION
The alarm system automatically switches off in order to limit the consumption of current in the motorcycle's battery, automatically
excluding the alarm functions but maintaining the immobilisation of the engine. In this condition current consumption is nil.
STOP MODE is activated 5 days after the system was armed by remote control or automatically (passive arming) if no alarms were
triggered in this time;
- If the motorcycle's battery is almost flat.
To exit STOP MODE, turn the ignition key ON: the siren will emit a series of BEEP sounds. Press the remote control within 5 seconds of
the BEEPS to disarm the alarm system. If the remote control is not pressed within 5 seconds, an alarm cycle will be triggered.
EMERGENCY BLINKER
The Motorcycle's Blinker can be armed by remote control.
To arm, press button A on the remote control 2 times when the ignition key is in the ON position.
To disarm, press button A on the remote control 1 time when the ignition key is in the ON position.
NB: When the Blinker has been armed by remote control and the ignition key is in the OFF position, the alarm can be armed: this will
automatically neutralise the internal lift and tilt sensor
PANIC
It is possible to trigger a 10 second alarm cycle by pressing the B button on the remote control. This alarm cycle can be interrupted by
pressing the same button again.
13