Publicidad
Step 14
Carefully turn your unit over onto its front edges. Lay the
å
BACK (H) over your unit with the unfi nished surface facing up.
Make equal margins along all four edges of the BACK (H). Push
å
on opposite corners of your unit if needed to make it "square".
Fasten the BACK (H) to your unit using the NAILS (1N).
å
NOTE: Perforations have been provided for access through the
å
BACK. Carefully cut out the holes needed.
Page 18
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
H
404962
1N
NAIL
(10 used in this step)
www.sauder.com/services
Publicidad
