Publicidad
Step 16
Carefully stand your unit upright.
å
Insert a free PIVOT HINGE (15H) through a WASHER (9I) and into the BOTTOM (F).
å
Insert the PIVOT HINGE, which is fastened to the DOOR (M), into the hole in the
å
STOP MOLDING (G). You will need to tilt your DOOR slightly.
Now, tip the DOOR in and fasten the free hinge to the DOOR. Use a BLACK 9/16"
å
LARGE HEAD SCREW (1S).
Fasten a KNOB (13K) and BACKPLATE (14K) to the DOOR (M). Use a GOLD 1"
å
MACHINE SCREW (50S).
NOTE: To make adjustments to the DOOR, loosen the SCREW in the PIVOT HINGE,
å
make needed adjustments, and tighten the SCREW.
Repeat this step for the other DOOR.
å
13K
50S
GOLD 1" MACHINE SCREW
(2 used in this step)
Page 20
14K
M
15H
9I
BLACK 9/16" LARGE HEAD SCREW
(2 used for the PIVOT HINGES)
G
F
1S
404962
www.sauder.com/services
Publicidad
