Care And Maintenance; Corrective Action - AquaSource 0475000A Manual Del Usuario

CARE AND MAINTENANCE

• Wipe faucet with a clean, damp cloth
• Use only mild dish soap with water
• Never use acids, harsh chemicals or abrasive detergents to clean surface
TROUBLESHOOTING
Problem
Leak from under handle
Aerator leaks or has an
inconsistent water flow pattern or misfitted
Water shuts off by itself
LIFETIME LIMITED WARRANTY
This faucet has been manufactured under the highest standard of workmanship. All parts of this
faucet are warranted to be free from leaks or drips during domestic use for as long as the original
purchaser owns this product. THIS EXCLUDES INDUSTRIAL, COMMERCIAL, OR BUSINESS USE.
The manufacturer will replace FREE OF CHARGE, under the warranty
condition, the entire unit or any part (at our option) which proves defective in material and/or
workmanship under normal installation, use and service. This warranty is limited to defective parts as
stated. All costs of removal and installation of the faucet, including the replacement of warranty parts,
are the responsibility of the purchaser. The manufacturer shall not be liable for incidental,
consequential, or special damages arising at or in connection with product use or performance
except as may otherwise be accorded by law. This warranty gives you specific legal rights, and you
may also have other rights which may vary from state to state. Any damage to this faucet as a result
of misuse, abuse, neglect, accident, improper installation, or any use violating instructions
furnished by us, WILL VOID THIS WARRANTY. When requesting warranty service, you will need to
present a copy of your sales receipt as proof of purchase. To obtain warranty service, call our
customer service department at 1-866-417-7564.
Possible Cause
Damaged valve
Aerator is dirty
Cartridge bushing
(Refer to Replacement
Parts List for diagram)
10

Corrective Action

Remove handle. Replace valve.
Unscrew the aerator to check rubber
washer, clean or replace the aerator.
Pull off handle screw cover.
Remove handle screw and handle,
then remove hub ring by turning
counterclockwise by hand. Locate the
brass cartridge bushing that sits on
top of cartridge and tighten a little
further using a wrench.