Hisense RB645N4WIF Manual De Instrucciones página 41

10. Change screw hole covers and screw
on middle cover plate from left to right
(as shown in figure below).
11. Lay the refrigerator on soft foam
packaging or similar material. Remove
both adjustable bottom feet parts③,
then remove the lower hinge part① by
unscrewing screws②.
①
②
③
12.Loose out the lower hinge pin,change
it to the reverse hole site, then tighten
it into position folllow the picture below.
13.Replace the lower hinge part to the
left side and fixing it with the special
flange screws. Replace the adjustable
bottom feet parts to another side and
fixing it.
14.Stand the refrigerator upright and
carefully slot the lower door onto the
lower hinge pin and hold in position.
Install middle hinge-left (in the plastic
bag) ensuring the lower door in secured
in place.
①
②
③
Lower hinge part
Special flange screw
Adjustable bottom feet part
15.Transfer the upper door to the
appropriate position. Secure the
door level, make the middle hinge axis
into the lower hole of the upper door.
Install the hinge② (provided in the
plastic bag)by screws①. Please hold the
upper door by hand when installing.
16.Take out the connector from the hole
on the top left side.Then connect it with
the door switch on the upper hinge
cover-left.
Electrical connector
17.Install the upper hinge cover② on
the left corner by
①
Self-tapping screw
②
Upper hinge cover-left
18.Open the upper door and install the
door racks and then close it.
Note:
If your appliance has handle, you have
to reverse handle by follow instructions
below.
Lever part① and part④, then loose
screws②. Change handle③ to the right
side, then install screws②, part① and
part④ in turn.
①
②
③
①
Handle cover
②
Special screws
③ Handle
④ Screw hole cover
①
Special flange screw
②
Upper hinge-left
Door switch
screw①.
①
②
④
①
②
14