Care And Cleaning - AquaPRO 33011-6 Manual Del Propietário

WARNING: Risk of electric shock. Can shock, burn or kill. Before
attempting to check why the unit has stopped operating, disconnect power
from the unit.
CAUTION: Do Not Change the preset tether length.

CARE AND CLEANING

CAUTION:Always use the handle to lift the pump. Never use the power cord to lift the pump. To avoid skin burns,
unplug the pump and allow time for it to cool after periods of extended use.
Do
 When the power is disconnected, inspect the
pump suction screen and remove all debris,
then plug the pump back into the grounded
(GFCI) outlet.
To clean a pump clogged with debris:
Unplug the pump from electrical power.

Unscrew the stainless screws, and remove the volute/bottom seal plate.

Use a flathead screwdriver to hold the shaft, then turn the impeller counterclockwise to release the impeller.

Remove debris from around the shaft and on/under the impeller.

Reassemble the pump.

Gasket
Volute
Stainless screw
33011-6 33011-4
33021-6 33021-4
33031-6 33031-4
Shaft
Impeller
30011-4
30021-4
30031-4
Do Not
 Do not disassemble the motor housing. This motor
has NO repairable internal parts, and disassembly
may cause leakage or dangerous electrical wiring
issues.
Do not lift up the pump by the power cord.

Stainless screw
Shaft
Impeller
Volute
6
Shaft
Impeller
Gasket
Bottom seal plate
Stainless screw
31011-4 31011-3
31021-4 31021-3
31041-4 31041-3