Surface Seal Application And Assembly - Pfannenberg PWT 6402 Instrucciones De Servicio

GB
Requirements
- Cooling units are free from the factory packaging.
- Observe the minimum screw-in depth of the M6 jack rings (1)
- M6 jack rings and cooling unit threads are free of damage (corrosion, deformation).
- The unit cover screws are removed.
Procedure
 Fully screw in the four M6 jack rings (1) with sufficient thread depth, see figure
 Check that the M6 jack rings are securely fitted in the cooling unit as prescribed.

The M6 jack rings are screwed in the cooling unit and the unit can be moved.
3.4.4

Surface seal application and assembly

WARNING
Danger of accident due to improperly fitted seals
Permeable seals may allow moisture to penetrate and cause short circuiting.
 Fit the seal so that it provides sealing against the switch cabinet.
 Always check seals during cleaning and maintenance work.
Surface seal application and assembly of the PWT air/water heat exchanger
Requirements
- Cut-out (1) for the air/water heat exchanger is fitted, see Assembly of the PWT air/water heat exchanger –
mounting the cut-out.
- The surface (2) is free of grease and oil.
- The unit is voltage-free.
Required tools and materials
- Surface seal (3), assembly tool
- Accessory kit: Sash fasteners, screws, nuts, washers
Procedure
 Adhere the self-adhesive surface seal (3) to the switch cabinet (2) with the chamfer to the front, in line with the
shape of the unit (4).
 Reinforcing the mounting surface creates an optimum seal between the air/water heat exchanger and the
switch cabinet.

The surface seal is fitted and the air/water heat exchanger can be assembled.
Operating Manual PWT 6402 230V / 400V 086100107 © Pfannenberg GmbH
Figure 9 - Surface seal application and assembly
.
Mounting M6 jack rings.
Page 14 / 30