Changing The Tines; Power Cord - SNOWJOE SUNJOE TJ605E-ELT Manual Del Usuario

NOTE: After each use, follow these steps to properly clean the
unit:
1. Remove soil, dirt, and foliage stuck in the tines, drive
shaft, tool surface, and vents with a brush or dry cloth.
2. Spray or rub biodegradable oil onto the tines.
3. Clean soiled grips with a damp cloth.
Always inspect the machine for damaged and worn parts after
each use. Check that safety features (i.e. labels, guards, etc.)
are in place. Check that nuts, bolts, and screws are tight.

Changing the Tines

NOTE: The machine is fitted with six tilling blades that can
easily be changed in pairs. Both of the steel blade tine pairs
can be fitted on the left or right, as required. Always change
both tine pairs at the same time to avoid imbalance and
damage to the machine.
To replace the tines, follow the steps below:
1. While standing on a flat and stable surface, switch off the
unit and remove the plug from the extension cord.
2. Remove the bolts and nuts used to secure the steel blade
tines, then remove the steel blade tines (Figs. 9 – 10).
Fig. 9
Bolt + Nut
Fig. 10
Drive shaft
Steel blade tines
3. Clean the drive shaft with biodegradable oil.
4. Place the new tines onto the drive shaft so that the holes
on the axles line up with the holes on the drive shaft
(Fig. 11).
Fig. 11
5. Insert the 2 bolts through the holes and secure them with
the 2 nuts.
IMPORTANT: The tines must be set in the correct turning
direction. Note the way the old tines came off and replace the
new ones exactly the same way.

Power Cord

If the power cord is damaged, it must be replaced in order to
avoid a safety hazard. Contact your authorized Snow Joe
Sun Joe dealer or call the Snow Joe
®
service center at 1-866- SNOWJOE (1-866-766-9563).
Repair
This product does not contain any parts that can be repaired
by the consumer. Contact an authorized Snow Joe
Sun Joe dealer or call the Snow Joe
®
service center at 1-866-SNOWJOE (1-866-766-9563) for
assistance.
Storage
• Examine the electric tiller + cultivator thoroughly for worn,
loose, or damaged parts. Should you need to repair or
replace a part, contact an authorized Snow Joe
Sun Joe dealer or call the Snow Joe
®
service center at 1-866-SNOWJOE (1-866-766-9563) for
assistance.
• Examine the extension cord thoroughly for signs of excess
wear or damage. If it is worn or damaged, replace it
immediately.
• Disconnect the extension cord from the electric tiller +
cultivator before storing.
• Clean the product as described above.
• Store the product and its accessories in a dark, dry,
frost-free, and well-ventilated place.
• Always store the product in a place that is inaccessible to
children.
• The ideal storage temperature is between 50ºF (10°C) and
86ºF (30°C).
• We recommend using the original package for storage or
covering the product with a suitable cloth or enclosure to
protect it against dust.
11
Align the holes
®
+ Sun Joe customer
® ®
+
®
+ Sun Joe customer
® ®
+
®
+ Sun Joe customer
® ®
+