Installation Instructions - Symmons Allura S-240-2-LAM-RP Instrucciones De Instalación Y Mantenimiento

Installation Instructions

If replacing an older faucet ensure water supply is
Caution:
turned before removing. Th en turn faucet control valves
OFF
to relieve water pressure.
ON
Step 1 Attach faucet to sink
■ Insert threaded
water inlets
through gasket
and mounting
holes.
■ Th read fl ange
gasket
nut along
flange
supply inlet
nuts
under sink.
Ensure larger
diameter end
is facing up toward faucet.
■ Hand tighten fl ange nuts while also ensuring faucet
and gasket are centered over mounting holes.
Ensure not to over tighten with pliers.
Step 2 Connect water supply lines
■ Plumb hot water
supply to left inlet
and cold water to
right inlet as viewed
from front of faucet.
■ Connect supply
line to supply inlet
with coupling nut
and tighten.
■ Check for leaks
if only replacing
faucet and drain is
already installed by fi rst turning faucet handles to the
position and then turn water supply valves
Step 3 Fasten drain body to sink
■ Remove stopper,
unscrew fl ange and
remove washer from
end of drain body as
shipped.
■ Apply plumber's
putty around
bottom of fl ange.
* Washer included
Note:
should only be used
when plumbers putty is
not available.
■ Move friction washer,
beveled washer and
fl ange nut down away
from end of drain body.
supply Inlet
coupling nut
supply line
.
ON
PLUMBERS
PUTTY
■ Place fl ange into
drain opening and
from under sink
screw drain body up
into fl ange at least 2-3
turns until hand tight.
■ Position
pivot cavity is facing
rear of sink and then
slide rubber beveled
supply
washer and friction
inlet
washer up against
sink.
■ Tighten fl ange nut up
against friction washer to evenly compress beveled washer
while also ensuring fl ange is centered in drain opening.
Take care not to over tighten fl ange nut.
Step 4 Install stopper and set eye position
Stopper can be removable or non-removable determined by
position of eye hole when inserting pivot rod.
■ Insert stopper
through fl ange
opening and
position eye hole.
Removing stopper
When installed in the
removable position,
move pivit rod to the
up position
(lift rod is in the down position when later installed).
Eye hole will slide over end of pivot rod.
Step 5 Attach pivot rod to drain body
■ Remove
OFF
nut and outer seat
from pivot cavity.
■ Insert pivot rod
into pivot cavity
so ball is against
inner seat and
rod passes under
stopper according
to selected eye
hole position.
■ Insert outer seat
over pivot rod with curved end against pivot ball.
■ Fasten pivot rod to drain body with retaining nut. Tighten
until ball is seated snug and pivot rod can move freely.
flange
Step 6 Connect lift rod and adjust linkage
washer *
■ Remove
(optional)
■ Fasten end of
hole in clevis strap that is best aligned to enable lift rod also
Page 2
drain body so
flange nut
drain
body
removable
retaining
small plug on back of faucet and insert lift rod.
pivot rod with spring clip through location
flange
beveled
washer
friction
washer
pivot
cavity
stopper
flange
non
removable
pivot rod
retaining nut
outer seat
pivot ball
inner seat
pivot cavity