Kemper PROFILER Guía Rápida página 9

afterwards. The upper left LED of the Effect Button should now reflect the category color of the effect you as-
signed. Now, you can activate or bypass the selected effect by stepping on the button on your Remote. To undo
a current assignment, simply perform the same assignment procedure again. To add a second assignment, just
repeat the process with another stomp or effect on the Front Panel. You will notice the upper right LED now in-
dicating the color of the second Effect Type. Multiple assignments can be done this way. Don't forget to store the
Rig, once you are happy with the assignments and the current on/off states. Whenever you load this Rig later, the
assignments and the on/off states are recalled just as they were when you stored them. A list of your current as-
signments gets displayed on the screen so that you don't lose oversight. On this screen you can also immediately
delete assignments without having to repeat the whole assignment process.
Here is an example: imagine you have a distortion in Stomp B, a chorus effect in Effect Modulation, and you want
to assign both to Effect Button I. Both effects are active at the moment. Press and hold Effect Button I, and press
the Module Button of Stomp B on the front panel. The upper-left LED of Effect Button I turns red to indicate the
Distortion Type, and the lower-left LED turns white to show that the effect is active. Now, press and hold Effect
Button I again, and press the MOD Button on the Profiler's front panel. The upper-right LED of Effect Button I
turns blue, reflecting the Chorus Type, and the lower-right LED turns white to show that the effect is active. Now,
when you step on Effect Button I, both effects will turn on/off simultaneously. These assignments will be lost, if
you don't store the current Rig before you load another one.
Now for another feature, based on the very same assignments: press the Module Button of the distortion stomp.
It will change its status, while the status of the chorus remains unchanged. Now, when you step on Effect Button
I, the status of both effects are swapped, and the white LEDs will reflect this accordingly.
✔ ✔
By setting the individual status of the Module Buttons that have been assigned to an Effect Button on the
Remote, you can create individual scenes of effects that are stored and recalled with the Rig.
In the event that your stage is so huge that your Profiler is miles away from the Remote, you will not be able to
reach both at the same time. In this case, enter the configuration page in the Rig Menu, select a Stomp or Effect
Module and use the four soft buttons on that page to complete the assignment. Besides toggling the status of
stomps and effects, each of the Effect Buttons can also be used to trigger so-called "Action & Freeze" functions,
for instance "Rotary Speaker (slow/fast)".
✔ ✔
On/off switching cannot be combined with "Action & Freeze" for the same button.
QUICK GUIDE 9