MTX Audio RTU8P Manual De Instrucciones página 3

Bass remote control port (EBC Remote) : use this port to connect the optional MTX EBC. It alows you to control the output level siting at the front of the car.
15A Fuse (15A) : When the fuse blows, replace it with the same value. Never use a higher rated fuse !
Phase switch (Phase) : two positions are available - 0° or 180°. Always try both and keep the one that produces more bass sitting at the front.
Bass Boost (Bass Boost) : It alows to raise the bass level @ 45Hz from 0dB to +12dB. Use it with moderation...
Low Pass X-Over Frequency Control (LP X-over) : Used to select the desired low-pass (LP) x-over frequency. The frequency is adjustable from 50Hz to 150Hz.
Installation & Mounting :
MTX recommends your new MTX RTU8P to be installed by an Authorized MTX retailer. Any deviation from specified installation instructions can cause serious
damage to the amplifier, speakers and/or vehicles electrical system. Damage caused from improper installation is NOT covered under warranty. Please verify all
connections prior to turn on your system !
1. Disconnect the vehicle's negative battery cable.
2. Determine the mounting place for your MTX RTU8P. Keep in mind there should be sufficient air flow for proper cooling.
3. Install a positive (+) power cable from the vehicle's battery through the firewall using a grommet or firewall bushing to avoid cable damage from sharp edges
of the firewall. Run the cable through the interior of the vehicle and connect it to the amplifier (+12V) terminal (1). Do Not connect to the battery at this time.
Note : Use only proper gauge wire for both positive and negative connections.
4. Install a circuit breaker or fuse within 20cm of the battery. This effectively lowers the risk of severe damage to you or your vehicle in case of a short circuit or
accident. Make sure the circuitbreaker is switched off or the fuse is taken out of the fuse holder untill all connections are made. Now connect your positive power
cable to the positive battery terminal of the battery.
5. Grounding - Locate a proper ground point on the vehicle's chassis and remove all paint, dirt or debris to reveal a bare metal surface. Attach the ground wire to
that contact point. Connect the opposite end of the ground wire to the (GND) terminal on the amplifier (3).
6. Connect a remote turn-on wire from the source unit to amplifier remote terminal (2). If the source unit does not have a dedicated Remote Turn-on lead, you
may connect to the source unit's Power Antenna lead.
7. Connecting signal cables to the amplifier : There are two ways to supply the signal to your MTX RTU8P.
• To get maximum performance, we suggest connecting a high quality RCA to the corresponding outputs at the source unit and inputs of the amplifier (6).
• If a source unit is being used without RCA outputs, use the included high-level amplifier's speaker terminals (8) using the right gauge speaker wire.
8. Double check all previous installation steps, in particular, wiring and component connections. Once verified, reconnect the vehicle's negative battery cable, turn
the circuit breaker on or place the fuse in the fuse holder.
Note : Gain Levels on the amplifier should be turned all the way down (counter clockwise) before proceeding with adjustments.
How To Stay Tuned :
https://www.facebook.com/MTXEurope
https://twitter.com/MTXEurope
http://www.mtxaudio.eu