Yamato 99289 Manual De Instrucciones página 8

Cod. 99289
To Suck Dust or Solids
Position the paper bag (1) (to buy as accessory), inserting it into the suction opening and pressing
so that it does not come loose.
Insert either the cloth filter (2) or the cartridge (3) filter so that it covers the whole float holder basket
located under the motor body.
To Suck Liquids
We recommend you keep the sponge filter but remember to remove the paper bag. Moreover,
substitute the cartridge filter with the sponge filter.
Operation
Before operating the machine ensure that:
1- According to the use (suction of either solids or liquids), the filter or the bag is installed correctly
2- The motor body is attached to the drum with the locking clips.
3- The accessories are suitable for the use.
4-The plug is connected to a suitable socket.
Press the switch to the "I" position and suction starts while, by pressing the switch to the "II" position
and connecting the electrical tool to socket (4), the electrical tool shall shart automatically on
switching on. (Fig1)
So, by connecting the connector (Fig.2) to the dust suction opening of the electrical tool and then
to the flex tube (Fig.3), you can pick up the dust straight into the aspirator. In this case suction shall
stop automatically without any need for any other action, a few seconds after the electrical tool is
switched off.
Fig. 1
filter cleaning button
While using the machine for the suction of fine dust (dry wall sander) you can squeeze the button
at the top of the head to make the cleaning of the filter.
USES
This machine has been built for home use to suck solids, dust and liquids.
On no account must it be used with: lit matches, embers and lit cigarettes, flammable, corrosive
and explosive liquid or gas materials.
Use is different according to the accessory used.
• Curved head: used to suck liquids in hydraulic pipes, in the bathrooms, washbasins, baths, etc.
• Narrow head: for places particularly small and difficult to reach such as corners, seats, etc.
• Large head: for wider surfaces like floors, carpets, etc.
To use the hydroaspirator as a blower, detach the sucking tube from the suction opening on the
side of the drum and connect it to the blowing opening located high on the motor body. (Fig.4)
This solution is suitable for blowing either leaves or light solids outside and on balconies.
Maintenance and Cleaning
This machine does not require any particular maintenance: if sucking dust, it is very important to
replace the paper bag periodically and according to the use you make of it, since an excessively
full bag might damage and affect the motor operation.
Connector
Fig. 2
8
Fig. 3