SUOMY MX SPEED PRO Manual Del Usuario página 18

WARNING
Thank you for choosing SUOMY.
Designed and manufactured in compliance with the highest qualitative
standards specifically for motorcycle use, MX SPEED PRO is certified
by the most important Certification Bodies.
Suomy cannot be held responsible for direct or indirect damages
resulting from an incorrect use of the product and/or for using the
helmet in situations that go beyond the normal conditions of use or
the modalities indicated in this booklet.
Before using the helmet, carefully read this manual. Keep it at hand
for future reference.
For further information, contact your Distributor or Suomy.
Use this helmet in compliance with the instructions contained in this
manual. Compliance with these instructions will make your helmet
last longer and will assure maximum product performances.
Modifications and/or alterations to the helmet and/or any of its
components shall make the warranty void and may jeopardize the
safety requirements or make the product non-compliant with the
certification standards.
All the Suomy products are constantly subject to a continual
improvement process, that's why Suomy reserves the right to make
changes, without prior notice, to the product object of this manual.
It is therefore not possible to exercise any rights on the basis of the
information, illustrations and descriptions contained in this manual.
MX SPEED PRO was developed and tested to assure, together with the
safety features, the best level of comfort and noise reduction during
ordinary conditions of use. However, the particular configuration of
the vehicle and/or the position of the rider or both factors can entail
18
situations that could not be foreseen during the manufacturing of the
product that may generate aerodynamic rustles or hissing sounds.
Suomy therefore, cannot be held responsible if this should occur.
MX SPEED PRO is not designed to be used with earphones and/or
similar devices.
NEVER USE AGAIN A HELMET THAT HAS
SUFFERED A SHOCK
A helmet that has suffered a shock must not be used anymore.
Sometimes damages are not visible from the outside however the
internal materials may be damaged. The helmet is designed for shock
absorption by alteration and partial destruction of some parts: in case
of further shock it won't be able to protect you with the maximum
safety.
WARNING! Never buy a used helmet or borrow someone else's helmet.
Over time the protective foam in helmets will adjust to the contours
of a user's head. A used or borrowed helmet may not offer as much
protection as a new helmet.
SHIELD CLEANING
The helmet shield is made of polycarbonate materials with a
polyurethane abrasion resistance coating. It should be cleaned using
mild soap and warm water. Never use hot water,salt water, benzene,
thinner, gasoline or any other harsh agents. Additionally the use of
commercial shield cleaners is not recommended because they may
affect the quality of the shield material. Treat carefully when cleaning
the shield to preserve the abrasion resistant coating. When deep
scrathes are visible, it is highly recommended that the helmet shield
be replaced. Tinted shield are for "Day time use only" and are not
suitable for use at night or in conditions of poor visibility.
STORE YOUR HELMET IN A SAFE PLACE
Do not keep your helmet on the rearview mirror or handlebar to avoid
damages to the comfort padding.
WARNING! An improperly stored helmet can become damaged and
may increase your risk of serious injury or death in an accident. You
should :