Taurus GALA 60 INOX Manual Del Usuario página 8

English
Cooker hood
GALA 60 INOX (Ver III)
GALA 60 WHITE (Ver III)
Description
A Switches
B One way valve
C Aluminium filter/s
D Lights
E Body
Installation
Be sure to remove all packaging material from
inside the appliance.
Make sure the air vented is not sent through the
ducts used to vent fumes from other gas or fuel
appliances.
Specific air venting regulations applicable must
be complied with when installing the appliance.
Respect the legal provisions concerning safety
distances from other elements such as pipes,
electrical connections, etc.
The minimum distance between the support
surface of the cooking elements and the lower
part of the appliance is 65-75cm. (This distance
can be greater if specified in the cooking
elements' installation instructions).
Do not cover or obstruct any of the openings of
the appliance.
The plug must be easily accessible so it can be
disconnected in an emergency.
Do not add new sections to the extraction tube
provided, as it could cause the appliance to
malfunction.
Make sure you have the necessary elements for
the installation before you start:
Impact drill
8 mm drill bit
6 mm drill bit
Philips screwdriver
Elements contained in the box for installation
(Fig.1):
1. 4X30 mm screws (6 pcs.)
2. Screw plug (6 pcs.)
3. One-way valves and upper outlet
4. Top cover
Assemblage
If you have an outlet to the outside, your hood
can be connected as shown in the image below
by means of an exhaust pipe (with an internal
diameter of 120 mm).
NOTE: Before installation, turn the unit off and
unplug it from the power outlet.
Before installation, you must remove the grease
filters as shown below, you must press the lock
and pull down:
There are two ways to install this cooker hood:
Mode 1:
To install onto the wall drill 2 holes of 8mm of
diameter on a suitable place according to the
center of the distance of hole in the back of the
cooker hood.
Insert the nut into the holes.
Insert the screws into the nuts and tighten. Put
the cooker hood onto the tighten screws.
Fix the cooker hood with safety screw. The two
safety vents are positioned on the back casing,
with a diameter of 6mm.
Put the one-way valve onto the cooker hood.
Mode 2:
Drill 4 holes of 6mm diameter at the bottom of
the hanging cupboard.
Put the one-way valve on the cooker hood, then
install the cooker hood on the bottom of the