Classic Accessories 52-001-010401-00 Manual Del Usuario página 7

Note: Assemble frame on a clean flat surface
next to your snow thrower for easy mounting.
ASSEMBLE THE BASE OF THE FRAME (FIG. 3)
6. Slide each side mounting bar [B1 and B2]
through an upper mounting post [K].
(Fig. 3a)
7. Snug (do not fully tighten) bolts on upper
mounting posts [K], so that they can be
adjusted when installing frame on lower
mounting posts [L].
8. Connect the center mounting bar [A] to both
side mounting bars [B1 and B2] by engaging
the spring loaded pins.
9. Insert the mounting bar ends [C] into the side
mounting bars [B1 and B2] by engaging the
spring load pins.
10. Repeat on other side.
ASSEMBLE THE FRONT AND BACk HOOP POLES (FIG. 4)
11. Insert the front top poles [E] into the front bottom poles [D].
Install each assembled front pole into the vertical tube on the
top of each side of the mounting bars [B1 and B2].
12. Insert the back hoop side poles [F] first into each side
mounting bar [C]. Insert another pair of back hoop side poles
[F] into the tops of the ones installed on the side mounting
bars [C].
13. Insert the back hoop corner poles [G] into the tops of the
installed sections of back hoop side poles [F]. Finish by
inserting the back hoop top pole [H] into both back hoop
corner poles [G]. You may find it helpful to twist the pole
when inserting it into a plastic sleeve.
Note: It may help to place the parts flat
on the ground for easier assembly.
Note: The back hoop side and corner
poles each have clear plastic sleeves on
one end. The frame hoop top pole DOES
NOT have clear plastic sleeves.
Remove protective
plastic caps from the
metal tubes on the
side mounting bars
[B1 and B2] prior to
assembly.
B1
C
Fig. 3
k
A
k
F
E
D
C
7
B1, B2
k
B2
G
H
F
Fig. 4
E
D
2X
Fig. 3a
C
G
F
F
C