Led Display; 7. Disassembly And Storage; Cleaning Instructions; Environmental Protection - BGS technic 2169 Manual De Instrucciones

LED DISPLAY

LED Status
LED lights up
green
LED lights up red
Reset necessary
LED blinks red
Protective mode,
no reset necessary

7. DISASSEMBLY AND STORAGE

Turn unit off and allow the unit and all attachments to cool for at least 30 minutes before disassembly,
cleaning or storage. Handling the unit or parts before they have cooled may result in injury; storage of
unit while still hot may result in damage to equipment or pose a fire hazard.
1. When you are finished working, turn the power OFF by releasing the power switch.
2. Disconnect the plug from the mains outlet or extension cord.
3. Once cooled sufficiently place unit and coils into foam cut outs in storage case.

8. CLEANING INSTRUCTIONS

A. Proper Cleaning Care
1. Make sure the unit is turned off and unplugged. Use a dry, clean, non-abrasive cloth or paper
towel to remove grease, oil, and other dirt from the INDUCTION HEATER and electrical lead
before returning them to the storage case.
2. For grease, oil and dirt that is more difficult to remove use a non volatile cleaning product.
Allow all components to dry completely before using the INDUCTION HEATER.
B. Improper Cleaning Care

Do NOT immerse any components of the unit in water or a cleaning solution.

Do NOT spray the unit with water from a hose, or wash any parts under a stream of water from a
tap or shower.

Do NOT clean any components with volatile organic compounds such as petrol, benzene,
kerosene, methyl ethyl ketone (MEK), fuel oil, brake part cleaner, paint remover and thinners,
varnish removers, plastic adhesive solvents, etc. These substances are fire hazards and will
harden or dissolve the polymer materials used in the INDUCTION HEATER components.

Do NOT use heat guns, microwave or gas ovens, etc. to dry the components of the INDUCTION
HEATER.

ENVIRONMENTAL PROTECTION

Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and disposed
of in a manner which is compatible with the environment.
DISPOSAL
Dispose of this product at the end of its working life in compliance with the EU Directive
on Waste Electrical and Electronic Equipment. When the product is no longer required,
it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information or give the product for disposal to
BGS technic KG or to an electrical appliances retailer.

BGS technic KG

Bandwirkerstr. 3
D-42929 Wermelskirchen
Cause
The unit is switched on and ready
to use
Switch unit off and on again (reset);
if the LED lights up continuously red again,
the following things should be checked:
Unit too hot
Coil spacing to workpiece too small
Other malfunction
The distance between
induction coil and component to be
heated is too small, the unit
interrupts the power supply at the
coil and heating up is no longer
possible.

Tel.: 02196 720480

Fax.: 02196 7204820
mail@bgs-technic.de
6
Switch off, let cool down
Use larger coil
Have unit checked
Increase distance, use larger coil.
The unit can be used again
immediately after correcting error
without prior switching off and on
again.
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Remedy
-----
V2007