Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
COMPONENTS
1
1
Spatula
2
Spatula cable connector
3
Spatula flexible cable
CONTROL PANEL
15
14
13
1
2 3 4
1
Power On indicator
2
On / off button
3
Wave type selection button
4
Run indicator
5
Start / Stop button
6
Pause indicator
7
Continuous wave indicator
8
Discontinuous wave indicator
9
Pulse wave indicator
10
Power display
11
Decrease power button
12
Increase power button
13
Increase time button
14
Decrease time button
15
Timer
2
3
12
11
10
5
6
7
8
9
REAR PANEL
1
1
Spatula cable connector
2
Power supply switch
3
Electrical power supply connector
4
Fuse
CONNECTION INSTRUCTIONS
● Connect the power cable to the rear panel of the
main body.
● Connect the flexible cable from the spatula to the
corresponding connection on the rear panel.
POWER AND CONFIGURATION
● Turn on the power switch on the rear of the
machine and press
The power indicator
will be in standby mode and ready for operation. On
the control panel:
- The timer will show 15 minutes.
- The power indicator will show 1.
- The continuous wave indicator
- On the
button, the pause indicator
will light up.
● Set the timer using the
to choose the operating time of the machine, in a
range of between 1 and 30 minutes.
● Set the power using the
to choose the power of the machine, in a range of
between 1 and 9.
● Wave type selection: use the
the type of wave.
- When the
indicator lights up, the type of
wave selected is continuous.
- When the
indicator lights up, the type of
wave selected is discontinuous.
- When the
indicator lights up, the type of
wave selected is pulse.
● Use the
button to start or stop the
device.
2 3
4
on the control panel.
will light up. The machine
will light up.
or
buttons
or
buttons
button to select
EN
3
Publicidad
Tabla de contenido
