Denso First Time Fit 471-7011 Instrucciones De Instalación página 3

5. Connect A/C compressor lead wire to vehicle harness.
6. To insure system performance and protection, always install a new receiver drier or
accumulator when replacing the compressor.
NOTE: Receiver drier or accumulator replacement is mandatory as a condition for warranty
acceptance.
7. Connect negative (ground) cable to battery.
8. Evacuate and recharge A/C system.
• Protect eyes and skin during recharging by using safety goggles and appropriate hand
wear.
• Connect manifold gauge set & vacuum pump/refrigerant charging station and evacuate
A/C system for a minimum of 30 minutes at 60-75 cmHG (24-29 inHG) of vacuum.
• Charge the A/C system with refrigerant per the factory specifications.
• Use the appropriate electronic leak detector to check the compressor and hose
connections for leaks.
• DO NOT overcharge the A/C system.
3