Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
FINAL ASSEMBLY
Connect battery and lamp plug to
4
charger board.
Units with Remote Lamp Wires:
Connectors provided are compatible
from 18 to 10 AWG on unit and the
remote unit. Use a fine tip flat head
screwdriver to open the connector
jaws.
Lamp connector
Battery connector
Remote connector
Federal Communications
Commission (FCC) Requirements:
This device complies with Part 15 of the FCC Rules.
This device may not cause harmful interference.
Battery Type
Total Load
NiCd – 3S1P
1.6 W
NiCd – 5S1P
2.25 W
Input
Wire
Wire
Voltage
No.
color
1
White
120V
2
Black
3
Orange
1
White
277V
2
Black
3
Orange
1
White
347V
2
Black
3
Orange
1
White
220V
2
3
Orange
*NOTE: Spare wire should be capped and tuck excess wire into junction
box or dress it into the slot of mounting plate as shown in step1, page2.
INSTALLATION and WIRING (CONTINUED)
Install the plastic film to housing.
5
Connect AC input plug to charger
board.
AC connector
WIRING DIAGRAM
Input from branch circuit. See label on wire
pair for voltage requirements.
NOTE: Refer table for operating voltages
Wire
Remarks
Label
Neutral
Hot 120V
Hot 277V
*Spare Wire
Neutral
Hot 120V
*Spare Wire
Hot 277V
Neutral
Hot 120V
*Spare Wire
Hot 277V
Neutral
Hot 220V
6
Plastic film
DC output to the remote units. NOTE: When you insert wires
to power a remote unit, the polarity that is chosen should
follow same convention over to the remote unit.
Status Indicator LED
Housing attachment to mounting
plate:
Make certain all wires and connectors
are routed to avoid interference with
other
components.
Align
openings on underside of housing
with latch buttons on mounting plate.
Firmly push housing straight onto
mounting plate, making certain all
four latches are fully engaged, and
the housing is closely aligned to the
mounting surface.
Battery
Lamp
(-)
Test Switch
page 3
latch
(+)
Publicidad
Tabla de contenido
