Battery Replacement - Quanum ELM2L Guia De Inicio Rapido

page 4
NOTE: Emergency lighting systems should be tested in
accordance with NFPA 101 or as often as local codes
require, to ascertain that all components are operational.
NOTE: Allow batteries to charge for 24 hours before
initial testing.
Manual testing:
If the batteries are sufficiently charged, press and hold the
"TEST" button on the bottom of the unit to activate a manual
diagnostic, during which the lamps will turn on. Once manual
testing is cancelled ("TEST" button released), battery
charging will be initiated.
IMPORTANT BATTERY INFORMATION:
Batteries are perishable items. For best results, it is
recommended that the batteries receive an initial charge
within the first six months of the manufacture date of the
fixture. The manufacture date can be found on the outside of
the unit packaging and on the product label as part of the
Date Code / Series. The first two digits in the date code
represent the year and the second two digits represent the
month. In many cases, batteries beyond the initial charge
recommendation time frame will recover if fully charged soon
after installation. If such a battery does not recover after a full
initial charge, it should be replaced.

BATTERY REPLACEMENT

Unit features and battery details shown may vary. See also "Battery Connection" step 4, page 3.
Disconnect AC plug from charger
1
board. Unscrew the screw and remove
the plastic film and save both. The
battery is under the plastic film.
Plastic film
AC plug
BATTERY HANDLING WARNINGS :

Dispose of used batteries properly.

Keep away from children.

Do not disassemble.

Do not dispose of in fire.
TESTING and MAINTENANCE
Disconnect battery plug from charger
2
board. Release battery strap. Replace
battery, secure the strap snugly, and
reconnect to the charger board.
Screw
Unit Status Indications
The "TEST" button illuminates to indicate the following conditions:
Basic version:
Indication: Status:
Off Unit is off
Off Unit is in Emergency operation
Solid green Battery is charging
Light green Manual test
Solid red Battery is disconnected
HO version:
Indication: Status:
Off Unit is off
Amber Unit is in Emergency operation
Solid green Battery is charging
Amber Manual test
Solid red Battery is disconnected
3
Re-assemble the unit including
attaching the plastic film. (see also
step 5 and 6, page 3).
Battery support
Battery strap
Release and reuse