Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
NOTE: NEVER LEAVE AN OPERATING UNIT UNATTENDED
With the Power Knob or Power Button in the OFF (
120V outlet. DO NOT FORCE THE POLARIZED PLUG INTO THE OUTLET; it will only fit one way.
The ThermaWave Ceramic Heater is versatile and designed to be placed in the center of the room
or closer to the wall (at least 3 feet away) for maximum convection room heating.
Model 850 Series - ThermaWave Ceramic Heater Operation
The Power Knob is equipped with two (2) heat settings:
1)
Low (
) – this setting uses 900 watts of power
2)
High (
) – this setting uses 1500 watts of power
Turn heater on by turning the Power Knob to either Low
(
) or High (
). The amber Power Light will come on.
Because the Low (
electricity to operate, it is more energy efficient. This may
be a better option if you are concerned about saving energy.
To set the Thermostat, turn the Thermostat Control fully
clockwise to the highest (
When the room reaches a comfortable temperature, slowly
turn the Thermostat Control counter-clockwise until both the
heating element and fan go off (the amber Power Light will
remain on). This is the point at which the Thermostat setting equals the room temperature. At this setting,
the Thermostat will automatically turn the heater back on and then off as needed to maintain the selected
temperature.
Turn the Power Knob to OFF (
4
) setting does not require as much
) setting.
) and unplug the heater when you are finished using it.
or
) position, plug the heater into a polarized
Model 850
Power Knob
Power Light
Thermostat
Control
Publicidad
Tabla de contenido
