Electric Driven Intallation - Brave BRM500 Manual De Instrucciones

BRAVE
INSTALLATION
Location
This machine should be installed by only qualified technicians. The machine should be set upon a
level surface where it will not be affected by strong winds, rain, snow, extreme heat, and freezing
temperatures. Install the machine considering locations for chemical pick-up, fuel connections,
electrical connections, water hook-up, venting, and maintenance.
Electrical Driven Installation
Electrical
Connect machine to an electrically grounded circuit that is fused or circuit-breaker-protected.
The circuit must match that which is specified in the ELECTRICAL section under MODEL
SPECIFICATION.
Extension Cord
The use of an extension cord that has undersize wire compared to the amp draw of your machine will
adversely limit the starting load carrying abilities of the motor and machine's performance. Use only
extension cords that are intended for outdoor use. These extension cords are identified by a marking
"Acceptable for use with outdoor appliances; store indoors while not in use." Use only extension
cords having an electrical rating not less than the rating of the product. Do not use damaged
extension cords. Use an extension cord in good repair free of frays or cracks in the outer covering.
Do not abuse extension cord and do not yank on any cord to disconnect. Keep cord away from heat
and sharp edges. Always disconnect the extension cord from the receptacle before disconnecting the
product from the extension cord.
WARNING: Risk of electrocution. Contact with power source can cause electric shock or
ADVERTENCIA: Riesgo de electrocución. Contacto con la fuente de alimentación puede
AVERTISSEMENT: Risque d'électrocution. Contactez avec la source de pouvoir peut provo-
800-350-8739

Electric Driven Intallation

causar la sacudida eléctrica o la quemadura.
quer le décharge électrique ou brûler.
burn.
www.braveproducts.com
Specifications
9