Machine Maintenance - Brave BRM500 Manual De Instrucciones

BRAVE
Shut Down - machine need flushed after each
use
1. Flip the toggle switch to the 'off' position.
2. Remove the nozzle.
3. Turn 3 way valve handle to the "down fresh water" position
closing off the chemical tank.
4. Attach a garden hose to the 3-way valve.
5. Turn on the water.
6. Clear water should be flowing from the wand.
7. Turn off water leaving it in "down fresh water" position.
8. Replace the nozzle.
9. Disconnect the garden hose and leave ball valve in "down fresh
water" position until you use the machine again.
10. If freezing conditions may exist, refer to STORAGE in

MACHINE MAINTENANCE

MACHINE MAINTENANCE
Checking the Tire Air Pressure
A.) Remove air fill cap
B.) Fill tire to 20psi (1.4bar)
C.) Replace air fill cap
Checking the Hoses
WARNING: Do not use a finger or skin to check for leaks. Escaping
fluid under pressure has sufficient force to penetrate the skin,
causing serious injury. Do not operate the pressure washer if the
hose is cracked, worn, or leaking.
A.) Check all hoses for leaks
B.) Check all hoses of worn areas
STORAGE
1.
Turn 3 way valve handle to the "up chemical tank position "opening the chemical tank.
2.
Drain the chemical from the tank.
3.
To flush the tank, fill it with fresh water.
4.
Remove the nozzle.
5.
Turn 3 way valve handle to the "up chemical tank position "opening the chemical tank.
6.
With the gun assembly in hand and trigger in "open" position flip the toggle switch to the 'on'
position.
7.
Open and close the trigger until there is steady flow from the wand to remove air in the line.
This will take 1 – 2 minutes.
8.
Flip the toggle switch to the 'off' position.
9.
Attach an air chuck to the air valve stem on the pump assembly. With the trigger gun in the
open position, apply air until a mixture of air and very little water is coming from the gun wand
10.
Remove the air chuck.
11.
Place machine in a dry place protected from weather condition.
800-350-8739 www.braveproducts.com
Specifications
13