Direction Of Rotation - Truper PRETUL ROTI-12P Instructivo

Start Up
General remarks for using the battery
The battery is shipped NOT CHARGED. It is necessary to charge the battery approximately 6 hours before being able to use it.
The normal charge is 32 °F to 113 °F. When not in this level the charge automatically stops until reaching the right temperature.
The normal temperature for discharge / work is 32 °F to 167 °F. If 167 °F are exceeded, the electronic control stops the tool
energy until the temperature reaches the temperature optimum new level. When the battery is below the normal tension while
working the tool stops working. Give the tool 15 minutes rest. In warm weather or after a long period of work the battery will get
too hot to recharge. Allow the battery to cool down before trying to charge again.
Bits or adaptors assembly
• Hold the handle firmly with one hand and with the other
hand turn the tip of the chuck counter clockwise, so that
the jaws loosen.
• Insert the bit until it stops or remove it whichever the
situation.
• Hold the Chuck base firmly with one hand and with the
other hand turn the tip of the cuck clockwise to secure the
bit.

Direction of rotation

• To bore and screw release the switch and and press the direction
button on the side where marks point towards the chuck.
• To reverse the turn, and unscrew press it on the other side.
• The drill switch will get blocked if the button sits in the middle.
CAUTION • The first time you turn on the drill and after
reversing rotation you might hear a click. This in normal and
does not represent a problem.
CAUTION • To prevent damaging the tool, never reverse
the rotation direction while the drill is running.
Speed selection
• The two speeds in the drill work in a similar manner to those
used in cars.
• Low speed (1) will give a lot of torque (torsion power). Use this
speed when starting to drill large orifices, be it wood or metal. This
will prevent the bit to get stuck.
• High speed (2) has a reduced torque but lets the drill operate
with higher revolutions per minute, that make the tool when in
the drill function to bore faster lean metal or wood.
Change from hammer drill / drill / drivers
• To bore concrete, tiled floor or materials similarly hard, turn the
function selection collar into the IMPACT (
strike and rotate at the same time onto the material.
• To bore metal or plastic turn the function selection collar into the
DRILL ( ) position to make the bit rotate against the material.
• For screw / unscrew turn the function selection collar to this position
( ) so the bit turns over the screw for better control.
• Do not try to drill metal, wood or plastic with the
WARNING
hammer drill in the IMPACT mode. Otherwise the tool efficiency would
diminish and the bit tip will get damaged.
Jaws
) position. The bit will
chuck tip
Forward Reverse
selection collar
ENGLISH
Function
7