HQ AVSPLIT-27 Manual página 2

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
How to connect the Switch-Splitter to your devices
1. Connect the HDMI cable from the HD sources to the AVSPLIT-27 input ports.
2. Connect the HDMI cables from your displays (monitor or projector) to the outputs of
the AVSPLIT-27.
3. Standard resolution of outputs set up:
The resolution of the first device plugged into the AVSPLIT-27 output will be
the default resolution of the other output. (If more than one HDTV displays are
connected to the AVSPLIT-27 before the power is turned on, the resolution will be
set by the HDTV display which is connected to the output port 8.)
4. Plug the 12VDC power supply into the AVSPLIT-27.
5. Turn on the main power switch witch located at the rear panel.
6. Check the input indication LED at the front panel. If the source devices are active,
but the LED is not on, please press the "SELECT" button once.
7. To turn the AVSPLIT-27 into sleep mode, press the "SELECT" button for 3 seconds.
The AVSPLIT-27 power light and input indicating LED will be off.
8. When connections are completed, the HDTV signal will be distributed to each
HDTV display.
9. For the best performance, you should re-start the AVSPLIT-27 power to make sure
the AVSPLIT-27 is working well in HDCP between DVD player and display devices,
when the HDMI cable was disconnected after your last use. (Please use the main
power switch at the rear panel to re-start the AVSPLIT-27)
Operations of the AVSPLIT-27
Note:
1. The AVSPLIT-27 is designed with Smart input source selection feature. The feature
provides auto detection of the active input sources for selection sequence. If the
input source is not active, it will not show in the selection sequence. For example,
4 sources are connected to AVSPLIT-27, but only input 1, input 2 and input 4 are
active; therefore, the selection sequence will work only between input 1, 2 and 4.
2. The POWER ON/OFF of some sources devices (ex. DVD) is designed to turn
the source into sleeping mode, but still send out an active signal. Under this
circumstance, if the selected source device is under sleeping mode, the LED will
not be lighted on.
IR Remote operation mode
Use the AVSPLIT-27 IR remote to turn on this box from sleep mode, the "power" LED
on the front panel will light on. Then use number button to select between sources,
or use the forward and backward button to select input sources.
Note: Only active input source can be selected.
CONNECTING AND OPERATION
1

Publicidad

Tabla de contenido
loading

Tabla de contenido