Assembly - Husky HOUC3304B11 Guía De Uso Y Cuidado

Assembly

1
Installing the casters
CAUTION: Do not over tighten the bolts.
□ Place the tray (I) on its side on top of the packaging material while
mounting casters to protect the product`s finish.
□
Mount the two swivel casters with brake (F) to the bottom of
the tray (I) using four bolts (CC) and washers (BB) per caster.
The s wivel casters with brake (F) should be installed on the
same side as the handle (D).
□
Mount the two rigid casters (H) to the tray (I) using four bolts (CC)
and washers (BB) per caster.
□
Tighten all bolts (CC) with a 13 mm wrench.
□
Carefully return the tool cart to its upright position.
BB
H
CC
3
Installing the cross supports, front rail
and bottle/can tray
□ Attach the front rail (L) to the legs as shown with two screws (AA).
Do not fully tighten screws at this time.
□ Attach the left cross support (E) as shown using two screws (AA).
Do not fully tighten screws at this time.
□ Attach the right cross support (E) and bottle/can tray (O) to the
legs using two screws (AA). Do not over tighten.
E
AA
L
I
F
E
AA
2
Installing the legs
NOTE: Do not fully tighten bolts yet to allow for some
movement during cabinet installation.
□ Mount the four support legs (G) to the tray (I) using two
screws (AA) per leg. Finger tighten only.
4
Installing the pegboard
NOTE: The pegboard is designed to attach to either
the left or right side of the tool cart, according to your
preference.
□ Attach the pegboard (N) to the legs of the cart using six screws (AA).
Do not fully tighten screws at this time.
O
6
I
N
G
AA
AA