Cleaning; Storage; Accessories; Troubleshooting - Craftsman 113.177135 Manual Del Usuario

SP6523-3.qxd 11/13/06
Maintenance (continued)

Cleaning

To keep your Wet/Dry Vac looking its best,
clean the outside with a cloth dampened
with warm water and mild soap.
To clean the drum:
1. Dump debris out.
2. Wash drum thoroughly with warm water
and mild soap.
3. Wipe out with dry cloth.

Accessories

Sears offers many specialized 1-1/4" non-
mechanical cleaning accessories that may
be used with this wet/dry vac.

Troubleshooting

Problem
Vac will not pick up dirt
Vac will not run
WARNING: If any of the power head assembly parts should become detached
or broken, exposing motor or any other electrical components, operation
should be discontinued immediately to avoid personal injury or further
damage to the vacuum. Repairs should be made before reusing the vacuum.
8:15 PM Page 11

Storage

Before storing your vac, the dust drum
should be emptied and cleaned. The cord
should be wrapped around the unit and
the hose should be stored as described in
the cord/hose storage section in this
manual. Accessories should be kept in the
same area as the vac so they can be
readily available. The vac should be
stored indoors.
Wet/dry vac accessories may be found at
all Sears retail stores and may also be
ordered from the Sears "Power and Hand
Tool" Catalog.
Cause
1. Clogged filter
2. Clogged hose
3. Air leak
1. No electricity
11
Remedy
1. Clean or replace filter
(follow instructions on
page 10)
2. Remove hose and
clear debris.
3. Make sure power
head is securely
attached to dust drum.
1. Make sure electrical
outlet has voltage.
(A qualified electrician
may need to be
contacted).