Lcd Display; Control Panel - Derby cycle impulse Guía Rápida

If, shortly after setting off or during a
journey, the left-hand LED blinks briefly
and then all LEDs flash, this means that
one of the problems described below is
present:
CAUSE SOLUTION
Spoke magnet has Make sure the spoke
slipped out of po- magnet has not slipped.
sition It should be as close as
possible to the sensor on
the chain stay (max. 5 mm
clearance).
Speed sensor Have your specialist cycle
defective shop check and, if
necessary, repair it
Cable connection Have your specialist cycle
defective shop check and, if
necessary, repair it
No connection › Connect the battery to
between motor unit
and battery
› Use a different battery
› Have your specialist
Only on Pedelecs with back-pedal brakes:
If the left-hand LED begins to flash with a
long flash, followed by short flashes from
all LEDs, this means that you must carry
out the system check for correct function
of the switch for operating the back-pedal
brake again or that the pedal positions
were not recognised correctly. In this
case, move the pedals forward once and
then back once, until you can feel some
resistance. If the flashing signal disap-
pears you can ride off normally. If the
flashing signal continues, you can ride as
if you were riding a bike without power
assist. Have a specialist dealer check your
error message and rectify the problem.
the charger
cycle shop check the
control cable that runs
from the battery plug to
the motor unit

5 LCD display

5.1 Control panel

The control panel on the handlebar grip
features four or five buttons (depending
on the model). The LCD display is located
in the middle of the handlebars, in other
words in the centre of the rider's field of
view.
On the right-hand side of the control
panel is the ON/OFF button. Press once to
switch the system on and press a second
time to switch it off.
The arrow buttons used to control the
level of assistance are located on the left-
hand side of the control panel.
The "Set" button is located between the
arrow buttons. It can be used to request a
variety of displays.
If the model features pushing assistance,
the switch for this will be on the under-
side of the control panel.
Quickstart Guide – Impulse
EN
23