Telephone Wiring And Jack Installation; Batteries - Cidco Communications D936 Manual Del Usuario

D936-937.book Page v Friday, August 30, 2002 10:24 AM
I
Unplug this telephone from the wall outlet and refer servicing
to qualified service personnel under the following conditions:
- If the power supply cord or plug is damaged or
frayed.
- If liquid is spilled into the unit.
- If the unit is exposed to water.
- If the unit does not operate normally by following the
operating instructions.
- If the unit is dropped or the casing is damaged.
- If the unit exhibits a distinct change in performance.
I
Avoid using the telephone during an electrical storm. There
can be a slight risk of electrical shock from lightning.
I
Do not use the telephone to report a gas leak if the leak is in
the vicinity of the phone
I
Ultimate disposal of this product should be handled according
to all national laws and regulations.
WARNINGS
WARNING
To prevent fire or shock hazard, do not expose this
product to rain or moisture.
CAUTION
To reduce the risk of electric shock, DO NOT remove
cover or back. No user serviceable parts inside.
Refer servicing to qualified personnel.
S
- SAVE THESE INSTRUCTIONS -
D936/D937 - 900MHz Cordless
CAUTION
Changes or modification to this device not expressly
approved could void the user's authority to operate
this equipment.
T W J I
ELEPHONE IRING AND ACK
I
Use caution when installing or modifying telephone lines.
I
Never install telephone wiring during an electrical storm.
I
Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
B
ATTERIES
CAUTION
To reduce the risk of fire, use only 3.6V 850mAh Nickel
Cadmium (Ni-Cad) cordless telephone replacement
battery pack.
I
Do not dispose of the battery pack in a fire as it will explode.
Check with local codes for proper battery disposal
regulations.
I
Do not open or mutilate the battery pack. Released electrolyte
is corrosive and can cause damage to the eyes or skin. It can
be toxic, if swallowed.
I
Avoid contact with rings, bracelets, keys or other metal
objects, when handling batteries. These objects could short
out the battery or cause the conductor to overheat resulting
in burns.
SAFETY INSTRUCTIONS
NSTALLATION
v