Installing The D936/D937; Check The Contents; Choose A Location For The Base Unit; Plug In The Adapter - Cidco Communications D936 Manual Del Usuario

D936-937.book Page 1 Friday, August 30, 2002 10:24 AM

INSTALLING THE D936/D937

C C
HECK THE ONTENTS
Verify that the following items are enclosed:
I
Telephone Base and Handset
I
Long Line Cord
I
Short Line Cord for Wall Mounting
I
Desktop/Wall Mount Wedge
I
AC Adapter
I One battery pack
I
Spare Battery (optional)
I
Belt Clip
I
User Manual
I
Quick Start Card
C L
HOOSE A OCATION FOR THE
The base should be away from all other electronic
equipment such as a personal computer, microwave,
stereo, or television. It is also a good idea to place the unit
away from noisy areas, or from heat sources such as a
radiator or direct sunlight.
P A
LUG IN THE DAPTER
a. Plug the AC adapter tip into the DC 9V jack on the base
and the other end into an electrical outlet. Verify that
the wall outlet is not controlled by a light switch and
that the tip is securely plugged into the jack. If the
optional spare battery is not charged, the phone will
not operate without AC power.
You must use a Class 2 power adapter that supplies
9 Volts DC and delivers at least 600mA. Its center
tip must be set to positive and its plug must fit the
phone's DC 9V jack. The supplied adapter meets
these specifications. Using an adapter that does not
meet these specifications could damage the phone
or the adapter.
B U
ASE NIT
D936/D937 - 900MHz Cordless
CAUTION
NEED TO KNOW
The installation of an AC surge arrester in the AC
outlet to which this adapter is connected to is
recommended. Telephone companies report that
electrical surges, typically lightning transients, are
very destructive to customer terminal equipment
connected to AC power sources.
INSTALLING THE D936/D937 1