Maintenance - ETI aL-90-850-MV Guía De Uso Y Cuidado

installation (continued)
5
Reinstalling the wire cover
□
Insert the wires and wire connectors into the fixture arm on the area light (A).
□
Reattach the wire cover to the fixture arm on the area light (A) with the wire cover screws removed earlier
using the M8 allen wrench (FF).
nOTe: Compatible with 1-5/8 in. mounting pole (available for purchase separately). For pole installation, use the pole clamp (DD) instead
of the wire cover.
Option a
Fixture
A
arm
Wire cover
screws
6
Restoring power
□ Restore power at the electrical panel.
□
Turn on the light switch to activate the
fixture.
□
Seal the area where the mounting bracket
on the area light (A) meets the wall with
silicone sealant.
nOTe: Test fixture at night or block the photocell to
determine if the fixture is lighting properly.
Option B
Wire
cover FF
FF
Mounting
bracket
Photocell
sensor
A
6

Maintenance

To replace the photocell
□
Twist the photocell sensor counter-clockwise and pull it from the socket.
□ Replace with a new photocell sensor (Model # EP-SL277-NC or standard NEMA 3 prong twist lock photocell
sensor equivalent).
□ Plug the new photocell sensor into the base and turn clockwise to tighten.
nOTe: The socket for the photocell sensor has one longer opening for the larger prong on the photocell. Align the longer prong with the
larger opening.
Wire
cover
Wire cover
screws
A
7
Please contact 1-855-384-7754 for further assistance.
www.ETiSSL.com