Package Contents - Grandstream GSC3620 Guía De Instalación Rápida

OVERVIEW
EN
The GSC3620 is a weatherproof infrared (IR) ceiling-mounted dome IP
camera with a 2.8mm-12mm vari-focal lens making it an ideal device for
wide-angle monitoring of nearby subjects in environments such as build-
ing entrances, corridors, banks, hotels, retail stores and offices as well
as narrow-angle monitoring of far field subjects in environments such as
streets, towers, warehouses, farms and etc. The electronic auto-focus
capability ensures plug-and-play installation without requiring manual
tuning or worry about loss of focus over time of operation. This device
supports motion detection and smart infrared technology for white bal-
ance and exposure to monitor activity at night in outdoor or dark enclosed
spaces. The GSC3620 can be managed with GSURF Pro, Grandstream's
free video management software, along with other ONVIF compliant vid-
eo management systems. It pairs with Grandstream's video phones and
GSC3570 HD intercom and facility control station for active end-point
monitoring and facility control. By adding weatherproof capabilities, this
is an ideal device for increasing security and facility management in any
indoor or outdoor area.
PRECAUTIONS
• Do not attempt to open, disassemble, or modify the device.
• Do not expose this device to temperature outside the range of -20 °C
to 60°C and environment humidity more than 95% (non-condensing)
• Please install camera correctly for a smooth operation.

PACKAGE CONTENTS

1x GSC3620
1x Waterproof RJ45
3 x Wall Anchors
and Screws
1x Drill Template Hex Keys
1x (M2.5) 1x (M2.0)
1x Quick Installation
Socket (5 pieces) Guide
~1~
POWERING AND CONNECTING THE GSC3620
The GSC3620 can be powered either using the right PSU (DC12V, 1A) or
using a PoE switch. Please refer to illustration below to do the wiring and
connect the waterproof RJ45 socket:
Option A (Recommended)
Step 1: Based on T-568B to install the RJ45 plug, tighten the connector
using the provided waterproof socket.
Step 2: Connect other end of the cable into a switch supporting Power
over Ethernet.
Option B
Step 1: Wire the cable and connect it to a network swicth like steps in
Option A.
Step 2: Connect a 12VDC, 1A (minimum) Power Adapter (not provided-
ed) to the power socket of the GSC3620 tail cable. Make sure the polarity
"+" (center) and "-" (outside) are correctly connected.
MOUNTING GSC3620
Step 1:
Use supplied drill template to drill holes at ceiling. Select appropriate an-
chors or screws based on ceiling material.
~2~
Ceiling