Belkin 8820np00425 Manual De Usuario página 80

ManUally ConfIGURInG neTWoRK seTTInGs
sections
table of contents
Manually Configuring network adapters in Mac os up to v9�x
In order for your computer to properly communicate with your Router, you will need to change your Mac computer's TCP/IP settings to DHCP�
1� Pull down the Apple menu� Select "Control Panels" and
select "TCP/IP"�
2� You will see the TCP/IP control panel� Select "Ethernet Built-In" or
"Ethernet" in the "Connect via:" drop-down menu (1)�
3� Next to "Configure" (2),
if "Manually" is selected,
your Router will need to
be set up for a static IP
connection type� Write the
address information in the
table below� You will need
to enter this information into
the Router�
Wireless G Router
1 2 3
(1)
(2)
4 5 6
4� If not already set, at "Configure:", choose "Using DHCP Server"�
This will tell the computer to obtain an IP address from the Router�
5� Close the window� If you
made any changes, the
following window will
appear� Click "Save"�
Restart the computer� When the computer restarts, your network
settings are now configured for use with the Router�
78
7 8 9 10