ASROCK K10N7SLI Manual Del Usuario página 17

2.5 SLI 2.5 SLI 2.5 SLI Operation Guide Operation Guide Operation Guide
2.5 SLI 2.5 SLI Operation Guide Operation Guide
TM TM TM TM TM
This motherboard supports NVIDIA
you to install two identical NVIDIA
cards. Currently, NVIDIA ® SLI
TM
and Vista 64-bit OS. Please follow the installation procedures in this section.
SLI TM Technology Requirements
1. You should have two identical SLI
certified.
2. Make sure that your graphics card driver supports the NVIDIA
technology. Download the latest driver from the NVIDIA
(www.nvidia.com).
3. Make sure that your power supply unit (PSU) can provide at least the
minimum power required by your system.
Enjoy the benefit of SLI Enjoy the benefit of SLI Enjoy the benefit of SLI
Enjoy the benefit of SLI Enjoy the benefit of SLI
Step 1. There is one ASRock SLI/XFire Switch Card factory-mounted on this
motherboard. This card served as a switch between the default mode (x16)
and SLI mode (x8 / x8). ASRock SLI/XFire Switch Card is factory-mounted
with its default mode (x16) side toward the retention slot base.
Step 2. To change it to SLI Mode, you need to reverse the direction of ASRock SLI/
XFire Switch Card. Please simultaneously pull open both the retention arms
that hold the card in position. The card itself will spring away from the
retention slot. Take it out gently by holding its edges, and keep away from
touching the connectors (Golden Fingers).
ASRock
® TM
SLI (Scalable Link Interface) technology that allows
® SLI TM enabled PCI Express x16 graphics
TM technology supports Windows
TM
-ready graphics cards that are NVIDIA
TM TM
TM TM TM
K10N7SLI Motherboard
® XP, XP 64-bit, Vista TM
®
® SLI TM
® website
1 7 1 7 1 7
1 7 1 7