Installation Instruction Of The Lamp Uv; Uv Lamp Cleaning - ICA Turbojet PLUS Manual De Instrucciones

Installation instruction:
16. Connect to power supply
Plug on and start the filter.
19. Assemble the power head
Open the pump head and clean the
filtering material as indicated in
steps 1-4. Put the uv lamp sleeve
on the hole on the media basket
and assemble the power head as
indicated in steps 5-8.

UV lamp cleaning:

21. Disassemble the valve base
Put the valve base handle in the
"unlock" position and take out the
valve base.
20
17. Adjust water output
Adjust the flow control handle to
adjust the water output.

Installation instruction of the lamp UV

20. Turn on the uv lamp, adjust the water flow
UV lamp
switch
Turn on the uv light to kill the bacteria in the water. When the light
indicator is on, you know it is working.
22. Take out uv lamp cover
Open
Separate the pump head as
indicated in steps 1-3, use a "+"
shape screwdriver to unscrew the
screw and take out the uv lamp
sleeve to clean.
18. Leakage confirmation
Confirm there is no leakage around
the bucket after power on. Confirm
again 30-60 minutes later.
UV lamp
indicater light
pumping
handle
23. Clean quartz glass tube
Take out the uv lamp cover, use a
wet towel or water to clean out
the dirt on the quartz glass tube.
Do not take off the quartz tube to
avoid that the water enters into
the circuit board and causes short
circuit.
Open
Close