Failure Shot - ICA Turbojet PLUS Manual De Instrucciones

Tips:
3. When assembling the inlet pipe, please make sure
the water in tank is above the minimum water level.
Minimum water level

Failure shot:

Probable
Situations
The power supply is unplugged.
Cannot
start
The impeller is stuck by foreign matter.
The impeller is not fixed well.
The water valve tap is damaged.
The water valve O-ring is damaged or with
The power head O-ring is damaged or with
Water
The power head and the canister are not locked
leaking
The PVC tubing and the water valve are not
The impeller cover O-ring is damaged or with
The impeller is stuck with foreign matter or not
Noisy
There is air in the canister filter.
The canister is not filled with water.
Abnormal
The water in the aquarium is too low.
start
The water valve taps are not open.
Inlet and outlet valve are not fully open.
Little water
Inlet and outlet pipes are too dirty.
output
Reasons
Pump head damage.
foreign matter.
foreign matter.
well.
connected well.
foreign matter.
The impeller is damaged.
fixed correctly.
The inlet tap is closed.
PVC tubing is too dirty.
Maximum water level
Treatment Method
Connect to power supply.
Replace with a new pump head.
Take out the foreign matter.
Fix the impeller well.
Replace with new water valve taps.
Replace with a new water valve O-ring or
remove foreign matter.
Change a new power head O-ring or remove
foreign matter.
Re-fix well.
Re-fix well.
Replace with a new impeller cover O-ring or
remove foreign matter.
Replace with a new impeller.
Remove foreign matter or re-fix the impeller.
Open inlet valve taps.
Shake canister filter body and let air out
completely.
Fully fill the canister filter casing with water.
The water in the aquarium must be above the
minimum level.
Open water valve taps.
Open the inlet and outlet valves fully.
Clean the inlet and outlet pipes.
Clean the PVC tubing.
4. The canister
filter must be
placed on flat
ground, 40-
110cm below the
water level.
23