Metra AXXESS LC-CHRC-01 Instrucciones De Instalación página 3

Installing the LC-CHRC-01
With the key in the off position:
• Connect the LC-CHRC-01 harness into the interface, and then to the harness in
the vehicle.
Note: For the Fiat 500L and Ram Promaster City, do not connect the harness to
the vehicle yet.
Note: If using the ASWC-1, connect it after you initialize and test the LC-
CHRC-01, with the key in the off position.
LC-CHRC-01
Initializing the LC-CHRC-01
Attention! If the interface loses power for any reason, the following steps will need
to be performed again. Also, if installing an ASWC-1 connect it after you initialize
and test the interface/radio, with the key in the off position.
For the Fiat 500L and Ram Promaster City:
• Turn the hazard lights on.
• Connect the LC-CHRC-01 harness to the wiring harness in the vehicle.
• Turn the key (or push-to-start button) to the ignition position and wait until the
radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the
off position, disconnect the interface, check all connections, reconnect the
interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Turn off the
hazard lights. Test all functions of the installation for proper operation, before
reassembling the dash.
For all other models:
• Turn the key (or push-to-start button) to the ignition position and wait until the
radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the
off position, disconnect the interface, check all connections, reconnect the
interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Test all
functions of the installation for proper operation, before reassembling the dash.
3