Basic Operation; Advanced Operation - Xtech HENDRIX XTS-614 Manual Del Usuario

1. Volume -/Previous track: Press this button briefly to decrease the
volume level. Press and hold this button to play the previous track.
2. Power (Play-Pause/Mode/Handset) button: Press and hold this button
to turn the speaker On/OFF. Double-press this button to cycle through the
available input modes. Press it briefly to play or pause audio or to resume
listening when a call has ended.
Hands-free mode:
• Press this button once to answer and end a call.
• Press and hold for about 1.8 seconds if you wish to reject an
incoming call.
• Press twice to dial the last number called (on supported devices).
3. Volume +/Next track: Press this button briefly to increase the volume
level. Press and hold this button to play the next track.
4. Micro USB charging port: Charges the built-in battery of the speaker
5. Aux input jack: Allows the connection of any device equipped with an
auxiliary 3.5mm audio connector (for wired playback). No other mode will
work, if a 3.5mm cable is plugged in.
6. Built-in microphone: For hands-free calling and conferencing.
Note: In order to use the microphone the ruber cover has to be open;
otherwise, the microphone will not work.
7. Status LED (located under the rubber cover):
• In Bluetooth mode, the LED blinks in blue to indicate that the device has
®
entered into the pairing mode and is ready to be detectable for the first time.
• The LED glows solid blue to indicate that the device is successfully
paired, or when the audio is paused.
• The status LED blinks slowly in blue while streaming music in BT and
auxiliary modes.
• The LED turns red when the battery is charging. The red LED will turn off
when the battery is fully charged.
8. Micro SD (TF) memory card: Allows music playback from compatible
TM
media files stored in a MicroSD
TM
storage capacity of 32G.
IV. Basic operation
• Use the supplied Micro USB cable to charge your portable speaker
directly from your computer, laptop or AC adapter.
• Make sure that your portable speaker is fully charged before using it for
the first time. Check that the LED light turns ON while the speaker is
charging. It will turn off when the speaker is fully charged and ready to use.
• The battery has to be initially charged for at least 3 hours. Thereafter, it will
take from 2 to 3 hours to recharge.
V. Advanced operation
Note: Before starting, please make sure your device has the built-in
feature available.
Bluetooth ®
(TF) memory card with a maximum