Technical Specifications - Xtech HENDRIX XTS-614 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Pairing two portable speakers with TWS technology
1. Make sure both speakers are in BT mode (follow steps above to allow
this function).
2. Press the Power button twice on one of the speakers to enter TWS mode.
3. A tone will be heard on both speakers once it enters pairing mode.
4. Once the devices are connected , the BT light in the main unit will stop
blinking, and in the second unit it will remain blinking, until it connects to
a mobile device via BT.
5. Connect the speaker to a mobile device via BT, once connected,  play a
song to verify that both units play the same audio file.
Note: If the speaker is in TWS mode when is turned off, it will still be in
TWS mode when it is turned on again.
VIII. Technical specifications
Device
Type
Maximum power output (RMS)
Buttons
Speaker
Driver unit
Maximum power output (RMS)
Frequency
Impedance
Sensitivity
Signal to noise ratio
Microphone
Directivity
Frequency
Impedance
Sensitivity
Connectivity
Connection type
Wireless RF frequency
Wireless range
Battery
Type
Charging time
Run time
Standby time
Charging method
Additional information
Dimensions
Weight
Cable length
Warranty
*Playback time may vary depending on each individual's playlist, usage and settings.
**Range estimate is based on an area free and clear of obstacles and interference, and within the
line-of-sight between both Bluetooth
2.0 channel wireless speaker
5W
Power (Mode/Play-Pause/Handset),
Previous track/Volume -, Next
track/Volume +
2.0in
5W
60Hz-20kHz
500mV
≥76dB
Omnidirectional
300Hz-15kHz
1kΩ
-300MV
Bluetooth
V5.0, Aux. 3.5mm and Micro SD
®
TM
2.4GHz-2.480GHz
Up to 49ft**
1200mAh lithium-ion rechargeable cell
2-3 hours
Up to 16 hours*
30 hours
Micro-USB
3.5x 3.5x2.5in
290g
Charging and 3.5mm audio cable: 1m
One year
V5.0 devices.
®

Publicidad

Tabla de contenido
loading

Tabla de contenido