Troubleshooting Guide - Hinkley 980004 Serie Guia De Inicio Rapido

If other fan or supply wires are different color, have this unit installed by a qualified electrician.
e. Push all connected wires up into junction box.
f. Reinstall the canopy on the mounting bracket.
g. Restore the electrical power.
3. REMOTE PAIRING PROCESS:
With the fan's power off, restore power to the fan. Press and hold "
the light kit will flash twice and the signal light on the handheld remote will come on when the button is pressed. The fan has completed the
pairing process with the handheld remote and is ready for use.
4. OPERATING TRANSMITTER:
A. H, M and L buttons: (Fig. D)
These three buttons are used to set the fan speed as follows:
H= high speed
M= medium speed
L= low speed
B. button:
This button turns the fan off.
C. The " " button:
The " " button turns the light ON or OFF and also controls the brightness setting. Press and hold the button to dim and brighten the
light. Press and hold the button and release the button at desired brightness. The light key has an auto-resume, it will stay at the same
brightness as the last time it was turned off.
D. " , and " buttons:
Pressing the timer buttons will automatically turn fan off after 2, 4, or 8 hours.
Please note that the timer buttons is active only when the fan speeds turn on. the light is not included.
You can cancel the timer by pressing
NOTE: The distance between the transmitter and receiver should not be greater than 30 feet. For best performance, make sure the Black
Antenna on the end of the receiver unit remains extended and not tangled with any of the electrical wires.
Fig.D
YOUR REMOTE NOW HAS FULL CONTROL OF THE FAN AND LIGHT.

5. TROUBLESHOOTING GUIDE

A. Fails to operate:
a. Power to the receiver?
b. Receiver wired correctly?
c. Fan manual speed control in highest position?
d. Light kit switch turned on?
e. Code set at exact same position in both transmitter and receiver?
B. Won't operate at distance:
If transmitter operates the fan and the light kit when up close, but not a 30 feet
away, try placing the black antenna wire higher; up through the ceiling, outside the
junction box.
NOTICE!
Your ceiling fan and light kit assembly must meet
the following requirements:
1. Do not use with solid state fans.
2. Electrical rating: 120V / 60 Hz
MAX. motor amps:1.0 A
MAX. light watts: 250 W
(Incandescent only)
For Warranty Information please visit www.hinkley.com
button and re-start the fan speed.
.
" button for about 5 seconds and release. If optional light kit is installed,