Maintenance - Dimplex CX-MPC Manual Del Propietário

Maintenance

The only maintenance required is
the replacement of the batteries.
When the batteries start to reach
the end of their life the controller
will display a low battery icon,
, above the temperature
reading. In conjunction with this
a periodic beep (every 2 minutes)
will be emitted from the unit until
the battery is changed.
To change the battery:
1. Remove unit from wall.
2. slide battery cover open on
the controller.
3. Remove and replace two (2)
aa batteries, into the battery
holder.
! NOTE: The day and time will
have to be reset once the bat-
teries have been replaced, but
the program will remain in the
memory.
4. Replace cover.
5. Remount on wall.
Battery must be recycled
or disposed of properly.
Check with your Local
authority or Retailer for recycling
advice in your area.
Figure 4
Batteries
Surface Cleaning
use a cloth dampened with warm
water only to clean housing and
glass display of the wall setter. Do
not use abrasive cleaners.
If the display needs to be cleaned,
putting the unit in the lock func-
tion will allow you to remove any
fingerprints or dirt without chang-
ing any settings.
Battery Cover
17