ASROCK K7Upgrade-600 Manual Del Usuario página 10

NOTE
When adjusting the jumper settings, you may use the tool, Jumper Cap Remover, to help you
removing the jumper caps more easily. This Jumper Cap Remover is bundled in your motherboard
package, and please follow the "Jumper Cap Remover Instruction" to use it properly.
PCI slots: PCI slots are used to install expansion cards that have the 32-bit PCI
interface.
AGP slot: The AGP slots are used to install a graphics card. Please insert the AGP
card with K7 AGP Interface into the slot 1.5V_AGP1 (see page 2, No. 33),
or insert the AGP card with K8 AGP Interface into the slot AGP2 (see
page 2, No. 30). Please do not install AGP cards into the slot
1.5V_AGP1 and the slot AGP2 at the same time. It may cause permanent
damage to the hardware.
Please do NOT use a 3.3V AGP card on the AGP slot of this motherboard!
It may cause permanent damage! For the voltage information of your
AGP card, please check with the AGP card vendors.
Installing an expansion card Installing an expansion card Installing an expansion card Installing an expansion card Installing an expansion card
STEP 1: Before installing the expansion card, please make sure that the power
supply is switched off or the power cord is unplugged. Please read the
documentation of the expansion card and make necessary hardware
settings for the card before you start the installation.
STEP 2: Remove the bracket facing the slot that you intend to use. Keep the screws
for later use.
STEP 3: Align the card connector with the slot and press firmly until the card is
completely seated on the slot.
STEP 4: Fasten the card to the chassis with screws.
1 0 1 0 1 0 1 0 1 0
ASRock K7Upgrade-600 Motherboard