Cequent REESE EXPLORE SportWing Hoja De Instrucciones página 3

Tools required for assembly: Adjustable wrench
Assembly Instructions
A. Insert threaded end of Wheel Hook Assembly through one of the holes in the Arm Support tubes.
Secure the Wheel Hook Assembly using the supplied T Knobs by tightening them onto the threaded
portion of the Wheel Hook Assembly.
B. Line up bottom hole of wing assembly with square hole of the shank assembly. Insert carriage bolt and
thread on the lock nut. Tighten with wrench. Repeat for other wing assembly.
C. Depending on the desired setting, insert bail pin and repeat for other side.
Vehicle Mounting Instructions
A. For 1‐1/4" Receiver hitch, simply slide the shank into the receiver and secure with pin and clip.
B. For 2" Receiver hitch, place angle brackets around support and align holes. Hold the angle brackets and
shank together slide into receiver and align holes. Insert cap screw and secure with washer and nut.
Tighten by securing nut with a wrench and turning the bolt with the allen wrench. Tighten so that
there is no play.
C. To access the rear of the vehicle without bikes loaded, remove bail pins and tilt wing assemblies to the
ground.
Instructions
Storage
In Use
Rear of Vehicle
Access