Siemens RDH100RF/SET Instrucciones De Funcionamiento página 5

Ocultar thumbs Ver también para RDH100RF/SET:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 13
Operating instructions
RDH100RF/SET consists of a RDH100RF wireless temperature controller and a RCR100/433 receiver. The
RDH100RF allows you to set the desired room temperature (setpoint) for the desired time. The unit features an
ergonomic setting knob for easy temperature control.
Display
Actual room temperature in ºC
The unit controls to the selected
comfort temperature
Indicates when there is demand for
heat
Replace batteries
Appears on the screen when the
RF
TEST
transmitter is being tested.
Battery compartment
Two alkaline batteries type AA, 1.5 V
Commissioning before start-up
Commissioning
· Remove the black transit tabs from the alkaline batteries.
· Check to see if the battery compartment is in the correct position.
· If no batteries are inserted, fit 2 alkaline batteries type AA in the battery compartment.
A6V101035988_en--_d
RDH100RF/SET
2018-06-21
Subject to alteration
Changing the batteries
1.
Get two new batteries of type AA alkaline, 1.5 volts.
2.
Within one minute: pull out the battery compartment and remove the
batteries, then insert new batteries and replace the battery compartment.
The original set values must be checked after changing batteries!
3.
Make certain the old batteries are disposed of properly, in
compliance with environmental requirements.
Energy saving tips without sacrificing comfort
·
Never allow room temperatures to exceed 21 C.
·
Air out rooms: Air out rooms for short periods with open windows and
Setting knob
doors.
RED regulation
Warmer/colder knob for
selecting the temperature
RDH100RF/SET
setpoint
·
Operating frequency: 433.94 MHz
·
Maximum Radio-Frequency power: 3.25 dBm
Siemens Switzerland Ltd. declares that the radio equipment type
RDH100RF/SET is in compliance with Directive 2014/53/EU. The full text of
the EU declaration of conformity is available at
www.siemens.com/download?A6V10223354.
Selecting the required temperature
· Turn the setting knob counter clockwise to
decrease the setpoint, or clockwise to
increase the setpoint in increments of 0.5 °C
· The required temperature is displayed next to
the comfort temperature symbol
The device is considered electrical and electronic equipment
for disposal in terms of the applicable European Directive and
may not be disposed of as domestic garbage.
· Dispose of the device through channels provided for this
purpose.
· Comply with all local and currently applicable laws and
regulations.
· Dispose of empty batteries in designated collection points.
Siemens Building Technologies / HVAC Products
DE
EN
FR
IT
NL
ES
PT
CS
HU
PL
SV
FI
ZH
TR
EL
RO
DA

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido