Kohler 25198-CP Instrucciones De Instalación página 6

1. Install the Spout
2-1/2"
(64 mm) Min
A 1" (25 mm) minimum to 1-1/4" (32 mm) maximum diameter mounting hole is
required.
Determine the mounting-hole location.
NOTE: The mounting hardware provided is for a standard deck thickness of 1/4" (6
mm) minimum to 2" (51 mm) maximum. For a deep rough-in installation where deck
thickness is 2" (51 mm) minimum to 4-1/2" (114 mm) maximum, order the deep
rough-in kit from kohler.com/serviceparts.
A 2-1/2" (64 mm) minimum distance is required between the finished wall and the
center of the spout.
A 1" (25 mm) to minimum to 1-1/2" (38 mm) maximum distance is required
between the sink edge and the center of the spout.
Drill a hole through the mounting surface according to the surface manufacturer's
instructions.
Insert the spout with tubes and wires through the mounting hole.
From under the sink, slide the rubber gasket and metal washer onto the stud.
If desired, add sealant to the underside of the escutcheon as needed. Wipe away
any excess sealant.
Thread the nut onto the stud and wrench-tighten to secure the spout to the
mounting surface.
1419479-2-A
1" (25 mm) Min -
1-1/2" (38 mm) Max
Spout
Tubes
Threaded
Stud
Rubber
Gasket
6
Metal
Washer
Nut
Kohler Co.
Sensor