Lucent Technologies Icon-Labeled 4400 Serie Manual Del Usuario página 9

Wall-Mounting the Telephone
You can mount all the 4400-Series telephones except the 4424LD+ on a wall by using the optional
color-contrasted stand. The DSS 4450 cannot be wall mounted.
The optional wall-mounting stand can also be used with all 4400-Series telephones
and the DSS 4450 to increase the viewing angle when used on a desk.
The wall-mounting stand is available in gray only. The ordering codes are as follows:
Small Wall-Mounting Stand for use with the 4400, 4400D, and 4406D+ telephones:
— PEC 4499-SML, comcode 108541210
Large Wall-Mounting Stand for use with the 4412D+ and 4424D+ telephones:
— PEC 4499-LRG, comcode 108541293
To wall mount a 4400-Series telephone, follow these steps to attach a stand to a 4400-Series
telephone:
Before you assemble the stand, you must have all cords attached and running
through their proper channels.
To use the stand to increase the angle of a 4400-Series telephone on a desk
follow the steps below but turn the stand around so that the thinner end of the
stand is at the bottom of the back side of the 4400-Series telephone and the
thicker end is at the top of the 4400-Series telephone.
1. Place the tab on the thicker end of the stand (this is the moveable tab) into the slot at the
bottom of the back side of the 4400-Series telephone
Icon-Labeled 4400-Series Telephones Assembly Instructions
CIB 3195 CALA
Issue 1, June 2000
Page 9