Checking Tire Pressure - Generac GC3000C Manual Del Propietário

Astilladora/trituradora
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

General Information and Setup
3. Fill tank with fresh, unleaded fuel with a minimum
85 octane rating to 1–1.5 in (25.4–38.1 mm) below
top of the fill neck to allow for fuel expansion.
NOTE: Do not overfill.
4. Install fuel fill cap. Secure tightly.

Checking Tire Pressure

WARNING
Loss of control. Do not overinflate tires. Overinflation
could cause a blow out, which could result in loss of
control. Loss of control could result in death, serious
injury, property or equipment damage.
1. See
Figure
2-13. Remove valve stem protective
cap (A) and check tire pressure using a tire pres-
sure gauge.
Figure 2-13. Valve Stem Protective Cap
2. Verify tire pressure is in accordance with recom-
mended pressure stamped on side of tire. Add or
remove air as needed.
NOTE: Do not over inflate tires.
3. Replace valve stem protective cap.
10
(000428)
A
010541
Owner's Manual for Chipper/Shredder

Publicidad

Tabla de contenido
loading

Tabla de contenido