ClearSounds CST25 Guía De Instalación Y Manual De Uso página 8

5. Program your area code
(A) After selecting the language, the display flashes "ENTER AREA CODE" and
DIGITS DIAL".
(B) If you dial your local calls using 7 digits (e.g., 555-
1212), then enter your local area code, press the
Dial button, and go to Step C.
If you dial your local calls using 10 digits (e.g., 303-
555-1212), then enter "000" as the area code for 7
digits dial, and press the Dial button to go to Step C.
(C) The display flashes "ENTER AREA CODE" and "10
DIGITS DIAL".
Enter the area code(s) for numbers that you dial
using ten digits (e.g., 720-555-1234). You can store
up to three area codes for ten-digit dialing. Press
Dial when you are done. If there is no number you
dial using ten digits, then press Dial.
6. Press the Save button to save these operating settings.
After installation, lift the telephone's Handset and listen for
the dial tone. If there is no dial tone, check to make sure all
cords are firmly plugged into their jacks.
Note: Programming your area code will allow you to easily
dial numbers that are in your CALLER ID list. See the Section "Calling Back a Number
from the CALLER ID List" for more information on dialing calls from your CALLER ID list.
Page 5
#00
_ _ _
ENTER AREA CODE
7 DIGITS DIAL
#00
3 0 3
ENTER AREA CODE
7 DIGITS DIAL
#00
_ _ _ - _ _ _ - _ _ _
ENTER AREA CODE
10 DIGITS DIAL
#00
7 2 0
ENTER AREA CODE
10 DIGITS DIAL
"7